Carlton 3500D, Руководство пользователя, Страница: 64 / 129

3500D SERVICING HYDRAULICS
42
SAFETY
•
NEVER SERVICE A MACHINE WITH THE ENGINE RUNNING, SEVERE
PERSONAL INJURY COULD OCCUR. TURN ENGINE OFF THEN REMOVE
IGNITION KEY AND DISCONNECT POSITIVE BATTERY CABLE TO AVOID
STARTING MACHINE ACCIDENTALLY.
•
CUTTER WHEEL MUST BE DISENGAGED BEFORE TURNING ENGINE
ON/OFF AND BEFORE SERVICING A MACHINE. OTHERWISE SEVERE
PERSONAL INJURY COULD OCCUR AS WELL AS MACHINE DAMAGE.
•
ALL MACHINE PARTS MUST COME TO A COMPLETE STOP AND HAVE
TIME TO COOL COMPLETELY BEFORE SERVICING A MACHINE OR
SEVERE INJURY COULD OCCUR, POSSIBLY SERIOUS BURNS AND/OR
DISMEMBERMENT.
•
PLACE THE CUTTER WHEEL ON THE GROUND WHEN PERFORMING
SERVICE ON A MACHINE.
•
RELEASE HYDRAULIC PRESSURE BEFORE PERFORMING ANY SERVICE
TO HYDRAULIC LINES OR OTHER COMPONENTS.
•
FLUID UNDER PRESSURE CAN PENETRATE THE SKIN AND CAUSE SEVERE
INJURY. SEEK IMMEDIATE MEDICAL ATTENTION IF SKIN IS
PENETRATED. CHECK HOSES AND FITTINGS USING A BOARD OR
CARDBOARD; DO NOT USE HAND OR FINGER. ALWAYS WEAR EYE
PROTECTION.
HYDRAULIC OIL & FILTER
•
Check hydraulic oil level daily , with engine off
and cool, and replenish as necessary. A site glass
is provided for easy viewing. If oil can be seen in
glass, there is enough oil in the tank. Do not fill
the tank more than 7/8 full; operating at high
temperature will cause oil to expand and spill over
if tank is full. Tank capacity is 4 gallons.
Remember to replace and tighten the cap.
•
The machine is equipped with Citgo AW32
hydraulic oil at time of manufacture; use same or
equivalent.
•
Drain and replace hydraulic oil at least once a year,
more often if oil is very dark or smells burnt.
Discard used oil properly.
•
Replace hydraulic filter every three to four months
of normal use. More often if used under severe
conditions. Use a 10-micron filter, available at
most locations.
•
Unscrew old filter and discard properly. Clean
filter housing and install new filter, making sure
old O-ring has been removed and new filter has a
new O-ring in place. Screw in new filter hand
tight only. Recheck oil level and refill if needed,
as described above.
REPLACE OIL FILTER
SITE GLASS