Carlton 3500D, Руководство пользователя, Страница: 51 / 129

3500D TROUBLESHOOTING GUIDE
29
COMPLAINT CAUSE CORRECTION
Cutter wheel stops turning.
•
Belt not engaged.
•
Belt loose.
•
Engine belt broke.
•
Poly Chain
®
belt broken.
•
Sheared key in shaft.
•
Broke cutter wheel shaft.
•
Adjust yoke assembly.
•
Tighten belt.
•
Replace belt.
•
Replace belt.
•
Replace key.
•
Replace shaft.
Roar in machine when cutter
wheel is engaged.
•
Belt guards rubbing on
jack shaft or cutter wheel
shaft.
•
Jackshaft or cutter wheel
bearings going bad.
•
Stub shaft bearing bad.
•
Re-position guards off of
shafts.
•
Replace bearings.
•
Replace bearing.
Bearing will not take grease.
•
Grease fitting clogged.
•
Replace fitting
Cutter head swings faster one
way than the other.
•
Counter-balance valve is
out of adjustment.
•
Cylinder bad.
•
Adjust counter-balance
valve to equalize swing
speed.
•
Replace cylinder.
Machine will not run with
remote hooked up. •
3-position switch on
machine control panel is in
off position.
•
6 pin connector pins are
touching and grounding
machine out.
•
Y-Connection in remote
cable pulled apart.
•
Position switch on
machine to remote and
remote kill switch to on.
•
Spread pins apart on inside
of connector.
•
Reconnect wires in splice
in remote cable.
For all Radio Transmitter or Receiver problems, see the Radio Control Manual included at
the back of this manual.