Carlton 3500D, Руководство пользователя, Страница: 42 / 129

3500D MACHINE OPERATION
20
•
Lower spinning cutter wheel to stump
and make a few light passes at stump to
get a feel for the cutting action.
•
Gradually increase cutting action and
work away at stump by swinging cutter
wheel left-to-right-to-left through stump
in a sideways motion. Smooth,
effortless cutting lengthens machine life,
minimizes downtime and is more
profitable in the long run.
•
Continue cutting stump by adjusting
cutting wheel progressively lower until
stump is cut well below ground level.
•
Swing cutter wheel clear of stump and
extend tongue to position machine closer
to stump for next series of passes and
continue cutting.
•
Continue in this manner until stump has
been removed.
•
Larger stumps may require repositioning
machine to work at best advantages.
•
Raise cutter wheel clear of stump and
return to center position.
•
Withdraw tongue extension.
•
Reduce engine speed to idle and
disengage drive belts. DO NOT TURN
OFF MOTOR. Engine must be allowed
to cool slowly at idle for 3-5 minutes to
avoid damage.
•
DO NOT DISENGAGE DRIVE
BELTS AT A HIGH ENGINE
SPEED.
Damage to belts and machine
will occur.
•
At low engine RPM cutter wheel swing
speed control needs to be closed for
cutter head to swing. Turn clockwise to
close.
•
Turn off motor.
•
Allow cutter wheel to come to a full stop
before inspecting work area.