Carlton 1712, Руководство пользователя

Страница: 33 / 165

12” CHIPPER SAFETY PRECAUTIONS
7
•
KEEP CUTTER DISK HOOD
CLOSED WHILE CHIPPER IS
RUNNING. Always make sure the
cutter disk hood latch pin is in place
and locked securely using a padlock
before starting chipper. The cutter
disk hood must be locked using the
factory issued lock pin and padlock.
•
Never open the cutter disk hood while
engine is running. After the engine is
turned off, allow the cutter disk to
come to a complete stop before
opening the cutter disk hood. This will
take several minutes
•
Never run the chipper or the engine
with the cutter disk hood open or
unlocked at any time or for any reason.
•
If the cutter disk hood or hinge is
damaged, replace immediately.
CUTTER DISK
HOOD
•
Always have at least 2 operators at the
job site running the chipper. One to
load the brush into the feed wheels and
the other to maintain the feed control
bar in case of an accident.
•
Always feed trees and brush butt end
first and walking to the right side of
the chipper, material being fed should
be to the operator’s left side. The
material being fed tends to kick to the
left and could injure anyone on that
side.
•
Never lean over material being loaded
into the feed wheels; especially small
diameter, short length material that is
still long enough to be fed into the feed
wheels alone. The material is not
heavy enough to hold down when the
feed wheels first grab it and will kick
up hitting the operator in the chin or
head causing injury.
•
Never lay vine type material in front of
feed intake chute.
•
Never allow yourself or your clothing
to become tangled in or tripped by vine
type material. SEVERE INJURY
COULD OCCUR.
•
Always cut vine type material into
shorter, easier to handle pieces,
approximately 4 to 5 feet.
•
Don’t feed the vines into the chipper
unless they have been cut!!!
•
STOP automatic feed system and run
vine type material through using
manual start/stop controls and a
wooden push paddle.
•
Always have the trees and brush cut to
size for the chipper before the chipper
arrives at the job site.
•
It is very dangerous to run a chain saw
and the chipper at the same time.
•
If a tree gets jammed and has to be
trimmed, shut down the chipper first.