G38xx14 Configuration Software
Manual armouring: Input
Operation:
Bistable channel used for switching on and off the intruder alarm. The output will start
flashing immediately upon detection of an intruder. Disable channels allow division into
zones. (Definition: Intruder alarm is active when somebody is at home. Some of the alarm
points (zones) may be switched off). A channel transmitter, place for instance in the
bedroom of the house, can be used for this function.
Parameters:
Armouring delay, desarmouring delay.
Door-lock armouring: Input
Operation:
Monostable channel type used for switching on or off the intruder alarm. As long as the
channel is activated, the alarm is maintained. When active, all alarm inputs are enabled,
including the disabled detector channels. Automatically disables all zones. (Definition: All the
alarm points (zones) are enabled when the house is empty.
Parameters:
Armouring delay, desarmouring delay.
Code lock armouring: Input
Operation:
Bistable channel type used for switching on or off the intruder alarm. Automatically disables
all zones. (Definition: All the alarm points (zones) are enabled when the house is empty.
Parameters:
Armouring delay, desarmouring delay.
Note:
By activating door-lock or code-lock armouring manual armouring can be desarmoured in
case somebody comes home after manual armouring has been activated.
Siren: Output
Operation:
The output is off when no intruder is detected. When an alarm occurs, the siren sounds
continuously until the siren time (0...20 min) has elapsed or the siren is switched off. During
normal operation the channel is off. The channel does not react on a transmit pulse.
Activation through logic will activate the output.
Parameters:
Siren time 0 to 20 min.
Selection of additional channels to blink together with the alarm output channel as well as
desired flash interval.
Alarm signal (silent alarm): Output
Operation:
The channel is normally off. Once an intruder is detected, the output will give out a 10 sec
pulse when the alarm signal delay has elapsed. During normal operation the channel is off.
The channel is used for transmitting information to eg an auto-dial modem. The channel
does not react on a transmit pulse. Activation through logic will activate the output.
Parameters:
Alarm signal delay 0 to 10 min.
Note:
The siren is stopped by deactivating the alarm in the same as the alarm was activated.
2000 Carlo Gavazzi Industri A/S. All rights reserved.
27
