DISxRSE Car Park Display
– Configuration manual
23
Set a dynamic IP address to the display
This procedure should be followed ONLY if the display is connected to a LAN network
and at least one DHCP server is available on the network.
To set the display in DHCP mode, you must be able to access the display before
changing the network settings.
Follow this procedure to set the display with a dynamic IP address.
STEP
ACTION
1
Click on the
Network Configuration
tab.
2
Check the
Enable DHCP
checkbox.
3
Click on the
Save Configuration
button to save the changes.
Note: You are redirected to the Reboot page.
4
The display is rebooted and shows the
Wait DHCP
…
message
until a valid IP address is
assigned. The new IP address is displayed on it.
5
See to
Note: When you change the network parameters, the display is rebooted.
The process may take about one minute.
The new IP address appears on the DISxRSE display during the start-up.