Volume Fill with Fast Fill Mode:
It is possible to Volume Fill and Fast Fill simultaneously. If
the gun is put into Volume Fill Mode, and then the Fast Fill
input is made high momentarily, the unit will run in Fast
Fill Mode until the volume programmed in for Fill Volume
is dispensed. At that time, the gun will be automatically
halted by the software. This happens regardless of the
condition of the gun trigger inputs so make sure the
applicator is triggered or an overpressure fault may occur.
When it is desirable to run both modes in parallel, it is
important to watch the Run output bit to ensure the unit
has in fact gone into Volume Fill Mode prior to sending
the Fast Fill bit.
Pushout
Type of input: Gun
Type of signal: Maintained
When this input is made high, it puts the gun in “Pushout
Mode”. When initiated, the RCS-2 will immediately turn
off the catalyst pump and speed up the resin pump to
maintain the target flow rate that was being sprayed prior
to the initiation of pushout mode. (Note that this pushout
bit must be maintained.) The RCS-2 will continue to
deliver fluid out of the first dual purge side until the volume
programmed in for Mixed Volume has been sprayed and
then that gun will automatically be halted by the software
(taken out of Run Mode). This state will be recognized by
the PLC or robot when the Run output bit from the RCS-2
goes false. For more information on using this function,
refer to the Operator’s Manual.
GUN INPUTS (VALUE)
Flow Setpoint
Type of input: Gun
Type of signal: Maintained
The allowable range of values for this parameter is any
integer from 0 cc’s/min to 10,000 cc’s/min. This is the
target flow rate for the output of the fluid panel associated
with this gun.
LN-9418-01-R0 (08/2018)
16 / 17
www.carlisleft.com
EN
INPUT
