0
System – Command Flags
(Future)
1
Gun 1 - Command Flags
Flags - see table 2.1 below
2
Gun 1 – Target Flow Rate
cc’s/min
3
Gun 2 - Command Flags
Flags - see table 2.1 below
4
Gun 2 – Target Flow Rate
cc’s/min
5
Gun 3 - Command Flags
Flags - see table 2.1 below
6
Gun 3 – Target Flow Rate
cc’s/min
7
Gun 4 - Command Flags
Flags - see table 2.1 below
8
Gun 4 – Target Flow Rate
cc’s/min
9
Gun 5 - Command Flags
Flags - see table 2.1 below
10
Gun 5 – Target Flow Rate
cc’s/min
11
Gun 6 - Command Flags
Flags - see table 2.1 below
12
Gun 6 – Target Flow Rate
cc’s/min
13
Gun 7 - Command Flags
Flags - see table 2.1 below
14
Gun 7 – Target Flow Rate
cc’s/min
15
Gun 8 - Command Flags
Flags - see table 2.1 below
16
Gun 8 – Target Flow Rate
cc’s/min
Data Contained
Word #
Units
TABLE 2 - RCS2 ETHERNET/IP IMPLICIT INPUT DEFINITIONS
Gun Command Flags
Bit #
TABLE 2.1 - GUN COMMAND
FLAGS WORD
0
Fast Fill
1
Channel Fill (Master)
2
Feather Set
3 Run
4
Halt/Fault Reset
5
Trigger 1
6
Channel Fill (Slave)
7
Trigger 2
8
Trigger 3
9
Trigger 4
10
Volume Fill
11
Push Out
12
13
14
15
GUN INPUTS (COMMAND BITS)
Fast Fill
Type of Input: Gun
Type of Signal: Pulsed, Triggered on rising edge
The gun must be in Run Mode or Volume Fill Mode prior
to initiating this Mode or the RCS-2 controller will ignore
the command. If the gun is configured as a single channel
gun and this signal is pulsed, the gun will cause the pump
to run at its maximum speed (typically 150 RPM) until the
halt signal is pulsed. (Note that it is not necessary to have
the trigger signal energized, flow starts immediately.) If
the gun is configured as a two-channel gun, and this
input is pulsed, the pumps will run at the maximum speed
possible while maintaining the target ratio. That is, the
software will determine which of the two pumps can be
run at its maximum speed and run the opposite channel
at whatever speed necessary to insure the proper ratio of
component A to component B. The software determines
this based on the programmed pump sizes and the
programmed ratio. Pulsing the Halt/Reset input takes the
gun out of Fast Fill Mode. (Note also paragraph below
describing using Fast Fill with Volume Fill.)
LN-9418-01-R0 (08/2018)
14 / 17
www.carlisleft.com
EN
INPUT
