Additional information
Vario II series
112
Operating manual
12.11
12.4 Backfeed/delay
In continuous dispensing mode (IO dynamic continuous, IO static
continuous, IO photocell continuous) no optimised backfeed is
possible. Because of the fact when changing the print order, then the
current label in the offset sector is already printed from the old print
order.
With activated double cut no optimised backfeed is possible.
In the sector that is printed when preprint the following label, no
date/time variable should be existing, because this could be refreshed
before the next start impulse.
Peel off:
After printing the label, it is driven into the
dispensing offset and waited there, until the label
was removed (photocell) or a new start signal is
given (IO dynamic). Afterwards it is again
backtracked to the beginning of label and then the
next label is printed.
Cutter:
After printing the label, it is driven into the cutter
offset; the label is cut and then backtracked
immediately to the beginning of label (if an operating
mode with backfeed is selected). Afterwards the
next label is printed, if necessary.
Tear off
edge:
After printing the last label of a print order it is driven
into the tear-off offset and the label res. labels can
be taken away. When starting a new print order, first
it is backtracked again to the beginning of label and
then the next label is printed.
If a following print order is available before driving
into the tear-off offset, then it is not driven into tear-
off offset but the following label is directly printed.
Peel off:
After printing the label it is driven into the dispensing
offset and then backtracked to the beginning of label
either immediately or after the set delay time. When
releasing a new start signal (IO dynamic) the next
label is immediately printed.
Cutter:
This is the same function as for 'backfeed standard'
as it is always backtracked immediately to the
beginning of label.
Tear off
edge:
After printing the last label of a print order it is driven
into the tear-off offset and then backtracked to the
beginning of label either immediately of after the set
delay time. When starting a new print order then the
next label is immediately printed.
If a following print order is available before driving
into the tear-off offset, then it is not driven into tear-
off offset but the following label is directly printed.
Backfeed operating
modes
Standard
Automatic