Additional information
Vario II series
110
Operating manual
12.11
12.3 Hotstart
Because of the fact that no battery-buffered SRAM is
available, the necessary data has to be saved in another
way, i.e. the data is saved onto memory card. Therefore
the option memory card is a condition for the hotstart menu
item.
The function hotstart contains e.g. that in case of a power failure the
currently loaded label can be further processed without any loss of
data.
Moreover a print order can be interrupted and to be continued after
switching on the printer anew.
At an active hotstart all necessary data is stored on the
memory card therefore do not remove the card during
operation. When removing during operation, this causes
the loss of all data on the memory card.
In case the hotstart function is set to on, at the start of a print order the
data of the current label is saved to the corresponding directory of the
memory card.
However the following conditions have to be fulfilled:
•
Memory card inserted in drive A
•
Memory card not write protected
•
Enough free storage space onto memory card
•
An error message appears in case these conditions are not
fulfilled.
At switching off the printer the state of the current print order is saved
to the corresponding directory of the memory card.
However the following conditions have to be fulfilled:
•
Memory card inserted in drive A
•
Memory card not write protected
•
Enough free storage space onto memory card
In case the hotstart function is set to On, at a new start of printer the
saved label data and the print order state is loaded from the
corresponding file on the memory card. Because of this reason a
memory card has to be inserted at switching on the printer. In case it
is impossible to load the data an error message appears.
Saving the current label
Saving the printer order
state
Loading a label and
print order state
