Carl Valentin C220, Инструкция по эксплуатации

Страница: 24 / 44

Replacing Components C220 / C300 / C400
24 Service Instructions 03.22
4.6 Replace the lower end position sensor on the
cylinder
WARNING!
Risk of injury by uncontrolled functions of the applicator.

Disconnect the printer power supply.

Close the compressed air supply before the work.
5
4
6
10
7
1
3
8
2
9
9
11
Figure 12
Removing the lower end position sensor (1)
(labelling sensor) on the cylinder
1. Remove the tamp pad and panel (see
chapter 4.1, page 19)
2. Pull the connector (5) of the sensor (1) from
the PCB (slot ST205).
3. Loosen the screws (6) to dismount the
energy chain (7) on one side.
4. Loosen the T-zipper (8) from the outside out
of the links of the energy chain (7).
5. Remove the sensor (1) from the groove of
the pad retainer (2) and pull it out of the
energy chain (7).
Installing the lower end position sensor (1)
(labelling sensor)
1. Fasten the new sensor in the pad retainer
(2), lay the cable and insert it into the energy
chain.
2. Press the T-zipper (8) into the links to close
again the energy chain (7).
3. Fasten the energy chain with screws (6).
Insert the plug connection on the PCB and
mount the panel.
NOTICE!
After replacing a sensor, its position
must be readjusted (see chapter 5.1,
page 27).