20
30% Ultimate ARF
Locate the fuel tank and hardware.
Assemble the tank with three lines.
Take one of the pieces of brass tube
and cut into two equal lengths. Bend
the other tube so it will go to the top
of the tank and fit into the raised
portion of the tank. The other two
tubes will just extend past the cap on
both ends. Connect the pickup tube
and clunk to one tube. After the
tank is installed, the vent line (tube
to top of tank) can be plumbed out
the bottom of the fuselage just in
front of the landing gear. The pickup
line (tube with line and clunk) can be
routed to the carburetor, and the
fill line can be routed to a filler
valve, fuel dot or just routed out the
bottom of the fuselage. The fill line
will have to be plugged to prevent
fuel from running out, the vent line
must be left open.
There is a laser cut tank mount fur-
nished with the plane. It is marked
front.
Tip the plate on edge and it will fit in
the cut out in the motor box sides.
Glue in place. This will place the
tank over the CG of the plane.
