
8
ENG
MasterAria +030220481 - rel. 1.0 - 12.11.2007
2. USER
The user interface is the “acqua” remote terminal, featuring a user-friendly
liquid crystal display.
2.1 “Acqua” remote terminal
In summary:
built-in NTC sensor to control the room temperature;
•
LCD with intuitive symbols;
•
selection of the value displayed (temperature, set point, off set from
•
common set point);
selective keypad lock (limited functions for offi
ces, hotels);
•
manual or automatic operation;
•
ON/OFF timer functions;
•
sleep function.
•
Below is a description of the terminal and the symbols shown on the
liquid crystal display:
AUTO
ON
OFF
HR
Fig. 2.a
butt.
meaning
Air handling unit (AHU) ON/OFF. If the remote ON/OFF digital
input is available, the function of the button can be disabled.
Used to select the desired operating mode: cooling(snowfl ake),
heating (sun), dehumidifi cation, ventilation, AUTOMATIC. If the
remote cooling/heating digital input is available, this button can
be disabled.
Pressing repeatedly sets the fan speed (min, med, max,
automatic=AUTO).
Confi rms to the changes made to the parameters.
Pressing once activates the sleep function, pressing again selects
the duration of the sleep function in hours (if more than three
seconds elapse from when the button was previously pressed, the
function is deactivated). After pressing 9 consecutive times, the
function is deactivated.
Holding the button sets the current time. Pressing once selects the
MasterAria ON time (changed using UP & DOWN), pressing again
selects the OFF time, and pressing a third time exits the timer
programming procedure.
Increase value (UP)
Decrease value (DOWN)
Tab. 2.a
Important:
The fan speed can only be selected using the fan
button if parameter 118 = 0.
AUTO
ON
OFF
HR
1
2
3
4
5
6
7
8
9
10
11
12
13
Fig. 2.b
Key:
1.
sleep function
2.
limited keypad function
3.
active alarm
4.
display value
5.
fan speed in automatic mode
6.
fan speed setting indicator (min/med/max)
7.
fan
8.
dehumidifi cation
9.
automatic operation
10.
cooling
11.
heating with heater
12.
heating
13.
current time
Below is a description of all the operating modes available on MasterAria.
The device can in any case be reconfi gured by the manufacturer of the
cooling/heating system or the installer (based on the features of the
system), and therefore some functions may be not available.
2.2 Operating modes
Cooling
Once having switched the device on, by pressing the ON/OFF button:
Repeatedly press the MODE button until the cooling symbol
•
(snowfl ake) comes on.
Set the set point (desired temperature) using the UP & DOWN
•
buttons.
Repeatedly press the fan button to select the desired fan speed; if AUTO
•
mode is selected, the speed is decided by the electronic controller
based on the deviation from the set point (the greater the deviation,
the higher the speed).
If the COOL ENABLE function is active, the fan is started only if the coil
temperature is low enough, to avoid undesired fl ows of hot air. If this
condition is not satisfi ed, the cooling symbol (snowfl ake) fl ashes.
Fig. 2.c
Содержание MasterAria
