Carel MasterAria, Руководство пользователя

Страница: 16 / 60

16
ENG
MasterAria +030220481 - rel. 1.0 - 12.11.2007
3.7 Programming key (copy the
confi guration)
Once having set the parameters (see the paragraph on “Confi guration“),
the confi guration can be quickly copied to other MasterAria controllers
using the programming key.
Proceed as follows:
switch off the previously programmed MasterAria (source);
1.
set the dipswitches inside the programming key (underneath the 2.
battery cover) to reading mode (dip 1= OFF, dip2= OFF );
insert the key in the 4-pin connector on the adapter, and connect the
3.
8-wire cable supplied (see Fig. 3.t);
insert the 8-wire cable from the programming key adapter to the IR
4.
connector on the board;
press the button. The red LED and then the green LED come on in
5.
succession, if the operation has been completed successfully. Other
signals indicate problems (see the corresponding instruction sheet);
remove the key and the adapter; set the dipswitch to write mode (dip
6.
1= OFF, dip2= ON ) and repeat steps 3, 4, 5, 6 to write the data to the
target MasterAria;
Important: to avoid excessively discharging the batteries in the
programming key, disconnect the normally closed digital inputs
on MasterAria. If this is not possible, use the key with the power supply.
The MasterAria parameters (source) can be copied to target devices with
the same or later software version.
Fig. 3.t
3.8 Network connection
A series of MasterAria devices can be connected via network to a
supervisor computer. In this case, a diff erent address needs to be set for
each device (parameter 69= Supervisory network address).
RS485
MasterAria 1
P69 = 1 MasterAria 2
P69 = 2 MasterAria 3
P69 = 3
Fig. 3.u