Carefree Universal Eclipse, Руководство по установке

Страница: 9 / 23

Carefree of Colorado
Installation Manual E
CLIPSE
052568-001r5 5
A
SSEMBLING THE
A
WNING
1. Decide on the location of the switches and control box to determine the cable routing.
2. If the motor and Direct Response sensor cables are to be routed through the RV wall at the bottom of
the arm, no modification is required. Go to step 3.
2.1. If the motor and Direct Response sensor cables are to be routed through the RV wall at the top of the
arm:
2.2. Remove the plastic wrap at the top of the motorized arm. Partially open the arm being careful to
not let the arm extend more than 6”.
NOTE:
The arm is under tension from the gas shock located in the arm.
2.3. Pull the cable(s) out of the slot(s) in the rear of the back channel and pull the cables out of the hole
in the top of the channel.
2.4. Secure the top of the arm in the closed position using a plastic wrap or equivalent.
3. For Aftermarket Installations: An extension
kit is furnished for aftermarket installations.
3.1. At the top of the arms, remove the rail
caps.
3.2. Attach the rail extension to the rail as
shown.
NOTICE
During assembly and
installation, The arm assemblies must
remain perpendicular to the roller
assembly. Failure to handle the arms
carefully can bend the drive shaft.
4. Align the roller assembly with the end cap on
the motorized arm assembly. Rotate the end
cap until the slot in the cap aligns with the
empty slot in the roller assembly, and then
press the roller assembly fully into the cap.
The end cap must seat squarely over the
end of the roller assembly when complete.
NOTE:
The roller assembly must be oriented with the fabric going over the roller toward the mounting surface.
5. Secure the end cap to the roller tube assembly using two #10 square-drive screws.
6. Repeat steps 4 and 5 to attach the non-motorized arm assembly to the roller tube assembly.
Remove Rail Cap
and Screws
Rail Extension Assy
#10-32 SHCS
and Nylock Nut
(2 per arm)
E0068
Roller Tube
Assembly
Align Slots
End Cap
#10 x 5/8 Screw (qty: 4)
End Cap
E0020a