Carefree Universal Eclipse, Руководство по установке

Страница: 10 / 23

E
CLIPSE
Installation Manual
Carefree of Colorado
6 052568-001r5
M
OUNTING THE
A
WNING
CAUTION
It is recommended that at least three people install the awning due to its
size and weight.
NOTE:
For the bottom 3 mounting holes: if mounting into structure, use the 1/4 x 1 1/2 screws; if not
attaching into structure, use the moly rivets.
The upper mounting holes must attach into structure using the screws provided. If structural backing is not
available for the upper mounting holes, it will be necessary to use the aftermarket rail extension so that the
upper brackets can mount into the structural members at the roof line.
1. Check the location where the awning is to be mounted. Ensure that the awning will not interfere with
other equipment on the vehicle, such as a slide out room, light fixtures, exhaust vents etc.
2. On the awning rail, mark the location of the centerline of the arm assemblies.
3. From those marks, measure down vertically a distance of 55" ± 1/4" from the centerline of the awning
rail. These will be the initial mounting holes.
4. Unroll the canopy one wrap.
5. With one person holding each arm, the third person should thread the polyrod (the plastic rod on the
edge of the fabric) into the awning rail, starting at one end. Carefully move across the vehicle, gently
pulling the fabric into the rail, until the awning is in the pre-determined location.
NOTE:
While the awning fabric is fairly robust, care must be taken not to snag it on the awning rail.
6. For installations without the rail extension: Align the first mounting hole in the motorized arm with the
location marked in step 2. The arm assembly must be perpendicular to the awning rail.
7. For installations with the rail extension: Butt the top of the rear channel against the awning rail as
shown in Detail A.
IMPORTANT NOTE: For Uniguard and Alumaguard installations, the centerline of the roll bar
must be 3/4" ± 1/4" above the centerline of the awning rail.
8. Drill a 5/32” hole at the first mounting hole for the RH (motorized) arm
8.1. If the hole goes into a structural member, attach the motorized arm using a 1/4 x 1 1/2” lag screw.
8.2. If the hole is through the outer skin only, ream the hole out to 1/4" and attach arm with a moly rivet.
55" ± 1/4”
E0022a
90
o
Typ.
Centerline
of Arm
Centerline
of Arm
Awning Length
Fabric Width
5” 5”
Awning
Rail
= Flat Mounting
Surface Area
4 1/4” x 70”
6”-7”
Clearance
from top of
door
6”
Drill Area for
Upper Cable
Routing
7 1/2”
68 1/4”
First Mounting
Hole (ref)
Drill Area for
Lower Cable
Routing
Align Top of Rail
with Bottom of
Awning Rail
Detail
A
Aftermarket Arm
Alignment