Carefree Universal Eclipse, Руководство по установке

Страница: 16 / 23

E
CLIPSE
Installation Manual
Carefree of Colorado
12 052568-001r5
Installing the Remote Receiver
1. Determine the location of the optional RF receiver:
1.1 Do not mount the unit near heat producing elements such as LP appliances or engine exhaust
components.
1.2 For best reception, do not mount the unit near or on a metal surface.
1.3 Mount the unit with the antenna pointing up.
1.4 The included cable is approximately 60 inches
long. Mount the unit close enough to the control
box so that the cord can be connected without
stressing the connections.
1.5 Allow room below the box to access the
connector jack, programming button and indicator
light.
2. Position the control box and secure using two (2) #6 x
1/2” screws.
NOTE:
If the box is mounted on a surface that is less that 1/2” thick, the screws will protrude through
the opposite side of the surface.
3. Connect the cable to the receiver.
4. If using the Ignition Lockout Sensor, route the cable to the splitter and connect. If not using the sensor
connect the cable directly to the control box
Programming the Receiver
These instructions apply to the current 433 MHz configuration of the remote and receiver. For older
versions (418 MHz) refer to the Eclipse Service Manual.
1. Power to the control box must be on.
2. Press and release the “Press to Learn Transmitter” button on
the bottom of the receiver box. The receiver is in program
mode when the red light comes on.
3. Press and release the stop button on the remote. The red
light will go out after the receiver learns the remote signal.
NOTE:
Pressing the stop button will cause the blue up
arrow button to default as the close (retract) function.
If a function button is pressed to train the receiver, it will
be programmed as the close (retract) button. Example:
Pressing the bottom button will program the bottom button
for retract and the top button as extend.
4. Repeat for each additional remote.
O
PERATIONAL
N
OTES
:

Transmitter and receiver operate on a frequency of 433 MHz.

The receiver exits the program mode after ten seconds.

If the light does not come on above, the memory is full and must be cleared. If the light still does not come on,
check the continuity of the cord between the boxes and repair or replace as required. Pin 1 of the 1
st
connector
goes to pin 1 of the 2
nd
connector etc.

If the light does not go out in above, the receiver already knows the transmitter's signal or the battery in the
remote needs to be replaced.

To clear the memory:
PRESS AND HOLD
the transmitter learn button. While holding the button, the indicator light
should be OFF for the full 5 seconds then come on.

The system may be programmed for up to 5 remotes. Additional remotes may be ordered separately.
DR020
T
O
EYE PO
R
T
on RP24 Program Mode Press to Learn T
ransmitte
r
UP
Program
Button Indicator
Light
Stop
3 7/8”
4 3/16”
1”
DR022
Screw, Truss Head
#6 x 1/2 (qty: 2)