12
Part number 3C4480 R10
May 2005
Fitting the facia
1.
Press the Molex 6471 socket onto the four pin plug on the
interconnect board.
2.
Push the interconnect board into the base plate so that the
Molex 6471 socket beds into the grommet.
3.
Push the interconnect board further until it is captured by the
clips on the base plate.
4.
Slide the facia attachment lugs into the guides at the rear of the
base plate.
5.
On the front of the facia, press down on the Cardax label until
the security screw hole lines up with the M4 threaded hole
underneath the base plate.
6.
Pass the M4 security screw through the hole in the facia and use
a tamper-resistant Torx-head tool to drive it into the threaded
hole in the base plate.
Removing the facia
1.
Using a tamper-resistant Torx-head tool, remove the M4
security screw from the underside of the facia.
2.
Pull the base of the facia away from the base plate.
3.
Slide the facia's attachment lugs out of the guides at the rear of
the base plate.
