Car-O-Liner Group AB
CTR9
68
49023, EN - rev. 4, 2020-01
6 Welding modes
Having switched on the spot welder, you have to select and determine the
type of welding process first. You may choose one of the following
processes: "Auto 1" , "Auto 2" or "Manual"
("Fully Automatic" is
default mode).
6.1
Fully Automatic mode
The Fully Automatic mode is default mode. In this mode all values are
automatically set, except caps.
1.
Select tool by pressing the "Change tool" button.
2.
Selected tool is displayed, in the given example the C-Tong.
3.
“Calibrate electrodes” will be displayed when entering “Full Auto”,
see section 8.2 Display information messages.
4.
Fitted (automaticaly detected) yoke is displayed.
5.
Select caps by pressing "up/down" button [a].
Check that cap size is matching your setting.
6.
Start welding by pressing C-Tong trigger.
7.
Succesfull welding! If welding is faulty, a red box with "X" is
displayed. A buzzing sound and red ligth in the handle display also
helps to indicate a faulty welding.
8.
After welding, measured material thickness is displayed.
9.
Displayed electrode force (daN) and air pressure (bar).
