Car-O-Liner Group AB
CTR9
46
49023, EN - rev. 4, 2020-01
IMPORTANT!
Risk for damage to materials close to the weld, e.g to glass
or textiles.
IMPORTANT!
Ensure that all electrical equipment within the welding
object is disconnected. Risk for interference.
IMPORTANT!
For good cooling efficiency, never operate the welder
without connecting it to the compressed air network.
IMPORTANT!
The welder may only be used by qualified personnel. The
user of the welder must have knowledge of spot welding and of alignment of
collision-damaged vehicles.
IMPORTANT!
It is the responsibility of the owner to ensure that the
equipment has been installed as specified in the instructions provided. It is
also the owner’s responsibility to ensure that the welder is inspected in
accordance with applicable regulations before use.
IMPORTANT
!
It is the responsibility of the owner to ensure that the work
place is well ventilated with a local fume extractor.
4.2
Starting the welding machine
The welding machine has been properly set up and connected to the mains.
Switch on the machine by the blue lit main switch. When the machine is on
the main switch turns green.
After the machine has been switched on, it takes
a few seconds for the weld-
ing control system to start the machine. During this time, the
Car-O-Liner logo is displayed on the screen. The C-Tong mode and Full
Auto mode will then be displayed on the screen.
Main switch
Figure 4.1 Starting the welding machine
