CTR12000 Car-O-Liner
Group
AB
41644, EN - rev. 2, 2012-09
29
3.3.1 Using edge welding caps
Recommended start setting value when using edge welding cap (part no
45785) in standard mode is CURRENT/kA: 6.0 and TIME/ms: 500 (Weld
parameters may vary depending on sheet thickness).
Attention:
If the welding spots are placed on the edge of the heat moulded
metal sheets
(see picture above)
, the metal sheets joints will be altered by the
increased temperature which will affect collision characteristics in a negative
way.
To avoid this, the welding spots must be placed as far inward as possible.
With edge welding caps, the OEM repair manual demands for the a-measure
(see picture above)
will be achieved.
