5
7. The Polarity Protection System GREEN LED is illuminated if the proper
connections have been made.
WARNING: If RED LED is illuminated, DISCONNECT the booster clamps from
battery terminals. Reconnect the booster clamps by reversing the
connections to the proper battery polarity.
8. Start the engine. Stop if the vehicle does not start after 2 to 3 seconds
of engine cranking. Wait 2 to 3 minutes then try again.
9. After Vehicle starts, disconnect the clamps by disconnecting the BLACK
CLAMP Negative first and then the RED CLAMP Positive.
1. Connect USB portable device into the unit’s USB port using the Power Bank
Micro USB cable provided or charging cable provided with USB device.
2. Press the Power switch and the Power Bank will start the charging process,
(The LED indicators will turn ON).
To turn the area light ON, press and hold the power button for 3 seconds.
To turn the area light OFF, press and hold the power button for 3 seconds again.
This will ensure that the battery gives its best performance now and on future
re-charging cycles. The charging adapters are for re-charging the battery only.
Always ensure that the area light switch is in the OFF position while charging.
1. Insert the 12 Volt DC Charger round Plug into the Li-ion Mini Jumper
Charging Port.
2. Connect the 12 Volt DC Charger Plug into the vehicle cigarette lighter
or 12 Volt accessory port.
3. Fully charge the Li-ion Jumper internal battery for 3 hours while the vehicle
engine is running.
4. Unplug the DC charger from the vehicle cigarette lighter or 12 Volt accessory
port first and then remove the round plug from the Li-ion Mini Jumper
Charging Port.
TO PREVENT OVERHEATING DO NOT CHARGE FOR MORE THAN 6 HOURS.
THE LI-ION MINI JUMP STARTER MUST BE FULLY CHARGED BEFORE
BEING USED FOR THE FIRST TIME. IT IS RECOMMENDED THAT THE
BATTERY BE RE-CHARGED EVERY 3 MONTHS TO ENSURE MAXIMUM
PERFORMANCE IN AN EMERGENCY.
Using The USB Charging Port
Using The Flashlight
Using The DC Charging Adapter
CHARGING INSTRUCTIONS
