CaptiveAire D76, Инструкция по установке, эксплуатации и обслуживанию

Страница: 30 / 44

30
Pulley Alignment/Proper Belt Tension
1. Belts tend to stretch and settle into pulleys after an initial start-up sequence. Do not tension belts by
changing the setting of the motor pulley , this will change the fan speed and may damage the motor.
• To re-tension belts, turn OFF power to the fan motor.
• Loosen the fasteners that hold the blower scroll plate to the blower.
• Rotate the motor to the left or right to adjust the belt tension. Belt tension should be adjusted to
allow 1/64” of deflection per inch of belt span. Use extreme care when adjusting V-belts as not to
misalign pulleys. Any misalignment will cause a sharp reduction in belt life and produce squeaky
noises. Over-tightening will cause excessive belt and bearing wear as well as noise. Too little
tension will cause slippage at startup and uneven wear.
• Whenever belts are removed or installed, never force belts over pulleys without loosening
motor first to relieve belt tension. When replacing belts, use the same type as supplied by the
manufacturer. On units shipped with double groove pulleys, matched belts should always be used.
2. All fasteners should be checked for tightness each time maintenance checks are performed before
restarting unit.
Belt tension examples:
• Belt span 12” = 3/16” deflection
• Belt span 32” = 1/2” deflection
Figure 18 - Pulley Alignment/Belt Tension
A. Belt Span Length
B. Deflection
C. Center Distance
B
C
A
Correct Incorrect
Incorrect Incorrect