Caple CM209WH, Техническая информация, Страница: 35 / 55

Component replacement and adjustment procedure
7.5
Ring element substitution
Figure 1
1. Disconnect the power supply cord and remove
the Oven from the cabinet.
2. Remove the upper, rear and lateral covers.
3. Disassemble the brackets by removing their
three screws each
(fig.1).
4. Remove the back support by removing the last
two screws on the top
(fig.1).
5. Remove ring element damaged by its screws
(fig.2).
6.
Disconnect the terminals on the heating
element in the rear side.
7.
Mount the new ring heating element with the
screws.
8. Replace the back support.
9. Connect the terminals.
10.
The connections must not be loose.
11.
Reinstall the Oven into the cabinet.
12.
Reconnect the power supply cord after the
Oven is installed.
13.
Run the Oven and check all functions and
microwave emission
(section 1.2).
Figure 2