38
EN
SETTING ANGLE OF AIR FLOW
Setting vertical angle of air flow
While the unit is on, use the SWING/DIRECT button to set the direction
(vertical angle) of airflow.
1. Press the SWING/DIRECT button once to activate the louver. Each
time you press the button, it will adjust the louver by 6°. Press the
button until the direction you prefer is reached.
2. To make the louver swing up and down continuously, press and hold
the SWING/DIRECT button for 3 seconds. Press it again to stop the
automatic function.
Setting horizontal angle of air flow
The horizontal angle of the airflow must be set manually. Grip the deflector
rod (See Fig.B) and manually adjust it to your preferred direction. For some
units, the horizontal angle of the airflow can be set by remote control.
Please refer to the Remote Control Manual.
NOTE:
on louver angles
When using COOL or DRY mode, do not set louver at too vertical an angle
for long periods of time. This can cause water to condense on the louver
blade, which will drip onto your floor or furnishings. (See Fig.A)
When using COOL or HEAT mode, setting the louver at too vertical an
angle can reduce the performance of the unit due to restricted air flow.
Do not move louver by hand. This will cause the louver to become out of
syne. If this occurs, turn off the unit and unplug it for a few seconds,
then restart the unit. This will reset the louver.
UNIT SPECIFICATIONS AND FEATURES
CAUTION
Do not put your fingers in or near the
blower and suction side of the unit.
The high-speed fan inside the unit
may cause injury.
Range
Deflector rod
Fig. B
Fig. A
Caution:
Do not keep the
louver at too vertical an
angle for long periods of
time. This can cause water
condensation to drip onto
your furnishings.
