30
EN
RESET Button
When you press the recessed RESET button,
all current settings are cancelled and the
control will return to the initial settings.
UP Button ( + )
Push this button to increase the indoor
temperature setting in 1°F increments to 62°F.
DOWN Button ( – )
Push this button to decrease the indoor
temperature setting in 1°F increments to 86°F.
NOTE: Press and hold UP and DOWN buttons
together for 3 seconds will alternate the temper-
ature display between the °C and °F scale.
SILENCE/FP Button
Active/Disable SILENCE function.
When the Silence function is activated, the
compressor will operate at low frequency and
the indoor unit will produce a faint breeze, which will
reduce the noise to the lowest level and create
a quiet and comfortable room for you. Due to
low frequency operation of compressor, it may
result in insufficient cooling and heating capacity.
During the heating operation (only when the
setting mode is HEAT), If this button is pressed for
more than 2 seconds, the “FP” function is
activated. The unit will operate at high fan
speed with the temperature automatically set to
8°C (46°F). The display window of the indoor unit
will display “FP”. For units without a display
, the Defrost indicator light will alternatingly switch
on for 2 seconds, and then off for
2 seconds. Press ON/OFF, SLEEP,
FP, MODE, FAN SPEED, UP, DOWN button
while operating will cancel the “FP” function.
FAN SPEED Button
Used to select the fan speed in four steps:
TIMER ON Button
Press this button to initiate the auto-on time
sequence. Each press will increase the
auto-timed setting in 30 minute increments.
When the setting time displays 10h, each
press will increase the auto-timed setting by
60 minute increments. To cancel the
auto-timed program, simply adjust the
auto-on time to 0:0.
TIMER OFF Button
Press this button to initiate the auto-off time sequence. Each press
will increase the auto-timed setting in 30 minute increments.
When the setting time displays 10H, each press will increase the
auto-timed setting 60 minute increments. To cancel the
auto-timed program, simply adjust the auto-off time to 0:0.
LED/FOLLOW ME Button
Disable/Active indoor screen Display. When pressed for more than
2 seconds, the FOLLOW ME function will be activated, press for
more
than 2 seconds again to disable.
LOCK Button
When you press the recessed LOCK button, all current settings are
locked in and the remote controller does not accept any commands
except the LOCK button. Press again to cancel the LOCK mode.
7
11
12
13
14
15
8
9
10
AUTO LOW MED HIGH
1
2
4
5
3
9
10
8
6
7
11
12
13
14
15
SILENCE
FP
MODE
SWING
SWING
ON/OFF
RESET
LOCK
TURBO
SELF
CLEAN
LED
FOLLOW
ME
TIMER
ON
TIMER
OFF
TEMP
FAN
SPEED
SLEEP
FRESH
F
auto
silence sleep follow me lock
run
cool
SET TEMP
TIMER ON OFF
dry
heat
fan