SETTING DISPLAY - PAGE 2
(3)
INCORRECT POSITIONING OF WOOD
• This figure shows the wood moves over. In this case, the pusher can't
touch the tail end of wood.
• When this problem occurs, you need to make length compensation.
• Use a steel rule to measure the distance from the tail end of wood to
the notch line.
• For example, if the distance measured is 40 mm, then you should
input a "-40"(mm) value in the "Length Comp.
mm".
TAIL ENd OF WOOd
puSHEr
STEEL ruLE
NOTCH LINE
dISTANCE TO BE
COMpENSTATEd
INCORRECT
POSITIONING
OF WOOD
TAIL ENd OF WOOd
WOOd MOvES OvEr
rEAr CuTTEr FrONT GuArd
puSHEr
EM-10 / EM-12
This manual describes the machine in current produce on.
We reserve the right to change the specifications without notice.
40
