C.MATERIAL WIDTH ADJUSTMENT:
Material width adjustment is done by moving the clamp bar to the appropriate set of adjusting bolt
holes. The holes are at 15 mm increments.
NOTE: For boards <19mm thick, replace clamp bar with the thinner one supplied, designed for
boards between 10-19mm thick. Refer to section “Part and Assembly Drawings” for further
instructions.
Sensor 1 (CUT HOME PROX.) sets the cutter retract stop (home) position, while sensor 2 (CUT
SPEED PROX.) determines where the cutter travel slows down to an arbitary speed when returning
home at full speed, they are factory set and can not be adjusted - located under the top plate at the
back of the machine.
Sensor 3 (CUT END PROX.) however, determines the cutter end point, and is automatically adjusted
with the board clamp guide. Minor adjustments can be obtained by moving the sensor plate to the
desired position.
REMEMBER TO MOVE THE CENTRE BOARD GUIDE WHEN MAKING WIDTH
ADJUSTMENTS, FAILURE TO DO SO MAY CAUSE A JAM UP AND EVEN MACHINE
DAMAGE.
EM-10 / EM-12
This manual describes the machine in current produce on.
We reserve the right to change the specifications without notice.
10
