SETTING DISPLAY - PAGE 2
4.
Length Comp.
0.00
inch
(1) When you set a value on the Out clamp
mm, generally the
wood can't move and position at the accurate position as you set. This
is caused by some factors, and that's why you need to make length
compensation to achieve an accurate positioning of wood.
In general, the higher feed speed of wood, the bigger compensation
value is required.
(2)
CORRECT POSITIONING OF WOOD
• The correct positioning of wood is the tail end of wood just align with
the line of notch of the cutter front guard.
• The correct positioning of wood means the pusher can just touch the
tail end of wood.
NOTCH
WOOd
CORRECT
POSITIONING
OF WOOD
rEAr CuTTEr FrONT GuArd
These two lines
should be aligned
puSHEr
NOTCH
LINE
EM-10 / EM-12
This manual describes the machine in current produce on.
We reserve the right to change the specifications without notice.
39
