Cansec Canlan, Руководство по установке

Страница: 31 / 31

CanLan Page 31 of 31
Installation Manual August 2014 • Rev. 1.2
Appendix I
TROUBLESHOOTING A CONNECTION
Invalid Configuration
If during startup, the Canlan determines that the current flash memory
configuration is invalid, LED B will flash on and off every second. The
Canlan will default to IP address 10.0.0.100. It is important to note the
status of LED B (RS485 Port Activity) if connecting through the Ethernet
interface.
Troubleshooting an Invalid Configuration
If LED B is flashing, first make sure all information entered in the
configuration software (including IP address) is correct and then press
SAVE .
Power off the Canlan, wait a few seconds, and power it back on again. LED B
should stop flashing while in the 20-second configuration mode. Recheck the
information entered in the configuration software.
Configuration vs Host Software
Host software such as Maestro or Smartlock Pro will be unable to connect to
a Canlan while an active connection exists between the Canlan and the
configuration software.
NOTE : if you are attempting to reconfigure a Canlan that has already been
configured, don't enter the default IP address (10.0.0.100). Use the IP
settings that were programmed into the Canlan when it was configured. If
you do not know the origingal IP settings, use a serial connection instead.