Cansec Canlan, Руководство по установке

Страница: 11 / 31

CanLan Page 11 of 31
Installation Manual August 2014 • Rev. 1.2
8. Connect the CanLan to the PC using the Cat5 crossover cable provided.
9. Continue to the Making a Connection section below.
Making a Connection
NOTE : When you power on the CanLan, it will enter a 20-second
configuration mode. LED B (RS485 Port Activity) will be illuminated during
the 20-second configuration period.
You must make a connection from the configuration software to the CanLan
during the 20-second configuration period. If the 20-second configuration
period expires before you make a connection, simply power the CanLan off
and then power it back on again. This will reset the CanLan and put it back
into configuration mode for 20 seconds, and you can attempt another
connection.
1. Go to Start>All Programs>Canlan>Launch Configuration Software .
2. Plug the 12V AC-DC adaptor into an electrical outlet, and plug it
into the CanLan.
3. This will power on the CanLan and reset the unit into a 20-second
configuration mode.
4. LED B (RS485 Port Activity) will be illuminated for 20 seconds.