Cansec Canlan, Руководство по установке

Страница: 18 / 31

CanLan Page 18 of 31
Installation Manual August 2014 • Rev. 1.2
COMMANDS
The configuration software provides a set of command buttons for reading
and writing the flash configuration as well as setting factory defaults. The
buttons and their actions are listed below.
Load
uploads the flash memory configuration from the Canlan
replacing the existing settings
Save
downloads the current settings to the Canlan and writes them
to flash memory
Version displays the Canlan firmware revision information
Default
sets all parameters to their default values in the configuration
software Note these defaults are not set in the Canlan flash
memory unless the
Save button is pressed
Connect initiates a connection with a Canlan
Quit
closes the connection with the Canlan and immediately begins
execution as per the selected operating mode