Canopus HDMA-4000, Руководство пользователя

Страница: 72 / 138

Reference 3
72
Serial control Serial control
The HDMA-4000 can be controlled from a device connected to the serial port.
The HDMA-4000 has two serial command modes: Pioneer LD/DVD mode, which is
more compatible with a Pioneer CD/DVD, and HDMA-4000(Ver.1.1x) mode, which
is a traditional serial control command mode.
These modes can be changed via a Web browser’s settings page. (See Reference 4).
N o
t e
Synchronized playback of the HDMA-4000 is only available in the Pioneer
LD/DVD mode.
- Connection
Connect a device which has a RS-232C port to the HDMA-4000 with a serial
cable (to connect to a PC, use a cross-over cable).
- Network transmission setting
The default settings are: 9600bps, 8bits, no parity, stop bits 1. The settings can
be modified with a WEB browser (See Reference 4).
- Command
The two characters, <CR>(0x0d) are required at the end of the command line.
When the connection and the settings are done properly, R<CR> is returned. If
an error occurs, xx<CR>* is returned.
* xx Substitutes for the error number.
Multiple commands can occur on a line (Up to 25 characters).
In command controls, do not issue further commands until a response has been
received to the previous one.
When network serial control is enabled on the Web console, the HDMA-4000
can be controlled with the same commands via the network. (Connect a device
to a specified port, 12000 is the default setting, with terminal communication
software such as Telnet.)
N o
t e
In serial control mode, files with the extension m2p, m2t or mpg are
recognized as content files.