Canon iR6570 series, Процедура установки

Страница: 22 / 62

Chapter 1
14
11) Loosen the screw [1], move the corona assembly
fixture [2] to the direction of the arrow (upper
right), and fix again.
12) Remove the connector [3] and pull out the primary
corona assembly [4].
F-1-25
13) Check the primary corona assembly, if dirt or
paper dust adheres to the assembly, clean it using
alcohol.
14) Remove the connector [1], unscrew the screw [2],
and pull out the pre-transfer corona assembly [3].
F-1-26
15) Check the pre-transfer corona assemblies, if dirt or
paper dust adheres to the assembly, clean it using a
solvent, 'Alcohol solution'.
16) Detach the dustproof glass [1].
F-1-27
17) Check the dustproof glass, if necessary, clean it
using the blower brush.
18) Insert the primary corona assembly, the pre-
transfer corona assembly, and the dustproof glass
into the machine in reverse order from removing
and fix them.
1. When using a solvent for cleaning, make sure that
the parts become dry completely.
2. When inserting the pre-transfer corona assembly
into the machine, be sure that it stays horizontal to
the process unit to avoid scratching the surface of
the drum.
3. Make sure that the one-way arm of the pre-transfer
corona assembly is located on the eccentric cam.
19) Perform the procedures of 7) to 10) in reverse
order, lock the fixing feeder assembly release lever,
and close the front cover.
When mounting the primary fan duct, make sure to
inlet the connector.
1.2.6
Installing the
Developing Assembly
0008-7955
iR5570 / iR6570
[3] [4] [2] [1]
[1] [2] [3]
[1]