Canon iR6570 series, Процедура установки

Страница: 29 / 62

Chapter 1
21
F-1-47
3) Attach a new paper size label to the paper size plate
of the deck.
4) After changing the size, register the new paper size
of the front deck in service mode.
Right deck: COPIER>OPTION>CST>P-SZ-C1
Left deck: COPIER>OPTION>CST>P-SZ-C2
A4=6,B5=15,LTR=18
1.2.17
Checking Images/
Operations, User Mode
0008-8105
iR5570 / iR6570
1) Press the reset key twice to go back to the main
screen. Check copying operations and images using
the test sheet.
- Copying operation: Make sure that copying
operation is normal.
- 2-sided copying operation: Make sure that paper
feed in the duplexing unit is normal.
- Pickup operation: Make sure that paper pickup from
each cassette is normal.
- Operating sound: Make sure that abnormal sound is
not generated.
- Fixed copy ratio: Check a copy image on a fixed
ratio basis.
- Multiple copying: Make sure that the specified
number of copies is normally made.
- Make sure that images on paper picked up from the
cassettes/decks are within the following specs.
The specs have the following 2 types:
Side registration (margin at the left edge of image):
2.5±1.5mm
Leading edge registration (margin at the leading
edge of image): 4.0+1.5mm/-1.0mm
Refer to [Adjusting Side Registration] or
[Adjusting Leading Edge Registration] if a result is
out of specs.
* If image density differs between left and right of a
copy, adjust the height of the rear of the primary
corona wire to correct.
The approx. first 10 copies may get soiled due to toner
dropped from the drum separation claw. However,
this will not occur as copies are made.
2) Set standard mode in user mode/service mode upon
request by user.
3) Load paper in the right/left deck.
4) Put back the right/left deck to the machine. Peel an
appropriate deck size label from the size label
(cassette/deck) board, and attach it to the paper size
plate of the deck.
F-1-48
5) Press the release button to draw out the cassettes 3/
4.
6) Peel an appropriate cassette size label from the size
label (cassette/deck) board, and attach it to the
paper size plate of the cassette. Set the paper size
plate to the cassette cover.
[1]
[2]
[3]
[4]
[4]
Deck size label