iPF8400S Basic Guide
109
Tro
ubl
esho
otin
g
P
rob
lem
s Reg
ard
ing Pap
er
Cause
Corrective Action
The Media Take-up Sensor cord is not connected to the
Right Media Take-up Unit correctly.
Reconnect the Media Take-up Sensor cord as follows.
1. Turn the printer off.
2. Disconnect the Media Take-up Sensor cord from the
Right Media Take-up Unit and reconnect it firmly, all the
way in.
3. Turn the printer on.
(See "Using the Media Take-up Unit (Optional).")
➔
User's
Guide
If the Media Take-up Unit continues rotating, contact your
Canon dealer for assistance.
The size of clear film cannot be detected
Cause
Corrective Action
The Platen is soiled with ink or other substances.
Open the Top Cover and clean the entire Platen.
(See "Cleaning Inside the Top Cover.")
➔
P.56
Margins are wide
Cause
Corrective Action
Rolls are advanced a specific amount before cutting to
prevent problems with cutting and paper ejection.
This operation is normal.
When
Cutting Mode
in the Control Panel menu was set to
Manual
, you selected
Do not perform
in response to the
Perform the detection of paper leading edge?
message.
Set
Cutting Mode
to
Manual
again, and select
Perform(recommend)
when the
Perform the detection of
paper leading edge?
message is displayed.
Note that when you select
Perform(recommend)
, if the
paper is strongly curled, the Printhead may rub against the
leading edge of the paper when the printing starts.
(See "Specifying the Cutting Method for Rolls.")
➔
User's
