Canon ImageRunner iR8500 Series, Руководство по обслуживанию

Страница: 201 / 655

COPYRIGHT© 2001 CANON INC. 2000 2000 2000 2000 CANON iR8500 REV.0 MAR. 2001
CHAPTER 5 MAINTENANCE AND INSPECTION
5-55
5.9.3 Stringing the Charging Wires
In principle, all charging wires (not the
grid wire) may be strung in the same way;
the following uses the primary charging as-
sembly as an example:
1) Remove the two screws [1], and detach
the shielding plate (left, right) [2] of the
charging assembly.
To prevent deformation (slack) of the
primary charging assembly, be sure to
work separately for the left and the right
shielding plates. (Do not loosen the
screws on the left and the right shield-
ing plates.)
2) Remove the wire cleaner.
For other charging assemblies,
remove the two covers.
F05-509-03
3) Free about a length of charging wire
(about 5 cm) from the charging wire
reel (0.06 mm in wire diameter), and
form a loop at the end (about 2 mm in
diameter).
Memo
To form a loop, wind the charg-
ing wire around a hex key once,
and twist the hex key three to
four times.
F05-509-04
[2] [1] [1]
Stud
Real
Charging wire
Charging
electrode
(Front) (Rear)
Chapter_05_2.p65 01/03/13, 14:41 55