Canon imageRUNNER C1335 Series, Руководство по обслуживанию

Страница: 420 / 607

7
7
7-49
7-49
Error•Jam•Alarm > Error Code > Error Code Details
Error•Jam•Alarm > Error Code > Error Code Details
Error
code Detail
Code
Item Description
E350 3000 Title System error
Description System error
Remedy
Contact to the sales company.
E351 0000 Title Main Controller PCB communication error
Description Communication function of the Main Controller PCB did not work properly.
Remedy
[Remedy] Replace the Main Controller PCB (UN81). (Unit of replacement:
MAIN CONTROLLER PCB ASSEMBLY)
E354 0001 Title System error
Description System error
Remedy
Contact to the sales company.
E354 0002 Title System error
Description System error
Remedy
Contact to the sales company.
E355 0001 Title System error
Description System error
Remedy
Contact to the sales company.
E355 0002 Title System error
Description System error
Remedy
Contact to the sales company.
E355 0003 Title System error
Description System error
Remedy
Contact to the sales company.
E355 0004 Title System error
Description System error
Remedy
Contact to the sales company.
E719 0000 Title Card Reader communication error (serial communication)
Description Communication with the Card Reader could not be started at startup.
Remedy
1. Check the connection of the Card Reader-F1, and turn OFF and then
ON the main power switch.
2. Remove the Card Reader-F1. NOTE: After performing the remedy
work above, go through the following to clear the error: COPIER>
FUNCTION> CLEAR> E719-CLR.
Error
code Detail
Code
Item Description
E732 0001 Title Scanner communication error
Description DDI-S communication error.
Remedy
[Related parts]
• Flexible Cable between the Scanner Unit (CIS01, CIS02/J911) and the
Main Controller PCB (UN81/J8101) (Unit of replacement: CABLE, FLAT)
• Scanner Unit (CIS01/CIS02) (Unit of replacement: CONTACT IMAGE
SENSOR ASSEMBLY)
• Main Controller PCB (UN81) (Unit of replacement: MAIN CONTROLLER
PCB ASSEMBLY)
[Points to note at work] When checking the harness/cable or connector,
perform the following work.
1. Disconnect and then connect the connector to check that there is no
bent pin and cable disconnection.
2. Visually check that the harness is not caught or open circuit.
3. If there is any error, replace the corresponding harness/cable.
[Remedy] Check/replace the related parts. After performing the remedy,
check that the copy image is output normally.
E732 0010 Title Scanner communication error
Description DDI-S communication error (Vsync detection error)
Remedy
[Related parts]
• Flexible Cable between the Scanner Unit (CIS01, CIS02/J911) and the
Main Controller PCB (UN81/J8101) (Unit of replacement: CABLE, FLAT)
• Scanner Unit (CIS01/CIS02) (Unit of replacement: CONTACT IMAGE
SENSOR ASSEMBLY)
• Main Controller PCB (UN81) (Unit of replacement: MAIN CONTROLLER
PCB ASSEMBLY)
[Points to note at work] When checking the harness/cable or connector,
perform the following work.
1. Disconnect and then connect the connector to check that there is no
bent pin and cable disconnection.
2. Visually check that the harness is not caught or open circuit.
3. If there is any error, replace the corresponding harness/cable.
[Remedy] Check/replace the related parts. After performing the remedy,
check that the copy image is output normally.