Canon imagePRESS C1 P, Руководство по обслуживанию, Страница: 1233 / 1265

Chapter 17
17-8
F-17-7
17.2.2 Installing the System Software (SST -> USB)
0013-8180
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / imagePRESS C1+
Here, you will be copying the system software from the SST to a USB device.
[Preparatory Work]
Requirements
- PC installed with SST version 3.22 or later
- USB device (*)
You will not be able to use a security-protected USB device. Be sure to remove the protection before use.
[Copying the System Software]
1) Start up the PC.
2) Connect the USB device to the USB port of the PC.
3) Start up the SST.
4) Click the USB icon on the Target Selection screen.
F-17-8
5) Select the drive to which the USB device has been connected.
*: USB Requirements
Interface USB 1.1 or higher (USB 2.0 or recommended)
Capacity 1 GB or more recommended
(A set of system software is in excess of 512 MB.)
Format FAT (FAT16), FAT32 (It must not be NTFS or HFS.)
single partition (There must not be multiple partitions.)
CONTROL Registerd Firms Found Firm
Registered fir mware F i r m wa r e r e g i s t ra t i o n c o m p l e t e d .
> > > B a t c h R e g i s t ra t i o n R e s u l t s
C l i c k a b u t t o n t o exe c u t e .
CONNECT
CANCEL
EXIT
O K
R e g i s t e r F i r m wa r e
D e l e t e F i r m wa r e
D e l e t e B a ck u p D a t a
S y s t e m M a n a g e m e n t
Service Support Tool DLM0 (Ver.3.22E)
iPR_C1
BOOT
XXxxvXXXX
USenvXXXX >>> Regist
SYSTEM
XXenvXXXX >>> Regist
TTS
XXenvXXXX >>> Regist
RUI
XXenvXXXX >>> Regist
LANGUAGE
XXxxvXXXX >>> Regist
BROWSER
Model Configuration Info : Update
OK
XXxxvXXXX >>> Regist
DCON
XXxxvXXXX >>> Regist
MEAPCONT
>>>
Regist
iPRC1
RCON
XXxxvXXXX
iRCXXXX
HDFormat
XXxxvXXXX
KEY
XXxcvXXXX
XXenvXXXX
MFP
USB
Target Selection CONTROL Export Firm Selection
MFP
USB
c:
CANCEL
EXIT
START
R e g i s t e r F i r m wa r e
E x p o r t F i r m wa r e
D e l e t e F i r m wa r e
D e l e t e B a ck u p D a t a
S y s t e m M a n a g e m e n t
S e l e c t t h e t a r g e t . C l i c k a b u t t o n t o exe c u t e .
S e l e c t t h e d e s t i n a t e d r i v e .
Select the destinate drive.
Series
Version
Firmware registration status
Service Support Tool DLM0 (Ver.3.22E)