![background image](http://html.mh-extra.com/html/canon/imageformula-dr-3060/imageformula-dr-3060_startup-manual_62946020.webp)
16
Installing the Scanner
SCSI ID and Terminator Settings
Use the DIP switches on the rear of the scanner to make the SCSI ID and
terminator settings.
For the DIP switches, the upper position is the ON position, and the lower
position is the OFF position.
1
ON
2 3 4
SCSI ID switches
Terminator ON/OFF switch
Factor settings
(Terminator: OFF; SCSI ID = 2)
SCSI ID Settings
Refer to the following table when setting the SCSI ID. If there are other SCSI
devices connected to or inside the PC, make sure to set a unique ID for the
scanner.
SCSI ID
SW2
SW3
SW4
0
OFF
OFF
OFF
1
OFF
OFF
ON
2
OFF
ON
OFF
3
OFF
ON
ON
4
ON
OFF
OFF
5
ON
OFF
ON
6
ON
ON
OFF
7
ON
ON
ON
Notice
When the scanner is shipped from the factory, the SCSI ID is set to "2."
Although any value from 0 to 7 is valid as a SCSI ID, "7" is normally reserved
for the SCSI host adapter, and should therefore not be used. In addition, "0"
and "1" are normally used by internal SCSI hard disks that are used for system
startup, so do not use these IDs either.
Содержание imageFORMULA DR-3060
