8-14
DOC. TOO LONG
The document is longer than
900 mm.
Use a copier to make a
reduced copy of the document
and then send the copy.
ECM RX
The fax is receiving a document
using Error Correction Mode
(ECM).
Turn off ECM if you need to
receive quickly, or if you know
your local lines are in good
condition (see <ECM RX>,
p. 7-3).
ECM TX
The fax is sending a document
using Error Correction Mode
(ECM).
Turn off ECM if you need to
transmit quickly, or if you know
your local lines are in good
condition (see <ECM TX>, p.
7-3).
MEMORY FULL
The fax’s memory is full because
it has received too many
documents, or a very long or
detailed document.
When <REC’D IN MEMORY>
appears on the LCD, press
[Stop] to print documents
stored in memory. Then start
again.
The fax’s memory is full because
you tried to send a very long or
detailed document.
Cancel delayed sending (see
p. 5-8) or delete any
documents stored in memory
(see p. 5-10).
If multiple pages are loaded,
separate the pages into
smaller stacks. If not, try
sending the document by
direct sending (see p. 5-2).
NO DATA
The one-touch speed dialing
button or coded speed dialing
code you entered has not been
registered.
Register the one-touch speed
dialing button or coded speed
dialing code (see p. 2-7 to 2-
8).
PRINT HEAD ERROR
During printing, the ink film
recording head may have
become too hot.
Allow the fax to cool down.
The fax will resume printing
when it has cooled down.
REC’D IN MEMORY
The fax received the document in
memory because paper or ink
ran out, a paper jam occurred.
Load paper in the paper tray
(see p. 1-8), replace the ink
film (see p. 8-4) or clear the
paper jam (see p. 8-1), then
press [Stop] to print the
document.
SET DOCUMENT
The document is not set in the
document feeder.
Set the document you are
trying to send or copy (see p.
1-9) and start again.
Message
Cause
Action