73
Printed : 1/9/02
73
20. Reconnect the coil harness connector. Slide it
onto the coil making sure it latches. Install a zip
tie over the latch. See photo below.
21. Reinstall removed components.
HEADLIGHT BULB REPLACEMENT
Consult the Model Specifications section of this
manual for the replacement bulb type.
1.
Remove the main fuse.
2.
Remove the straps from the left fork leg and
notice the brake line and odometer sensor
routing. When reassembling make sure the
routed lines are on the inside of the headlight
bracketing.
3.
Tilt the headlight out slightly and remove the
housing screws and remove the bulb housing
from the headlight body. The headlight has two
lamps, the process is identical for both.
NOTE :
Note the fit and form of the housing as you remove
it. Later, install the housing as removed or a gap
between it and the headlight body may result. A gap
will allow water and debris to enter the inside of the
headlight causing damage.
4.
Remove the bulb unit from the socket and
install a replacement bulb.
5.
Re-strap the headlight to the fork leg making
sure the strap catches are connected properly.
6.
Test the headlight for proper operation.
1. Latch
2. Zip tie
1. Strap
2
1
1
1. Housing
2. Screws (upper bulb)
2
1