57
Printed : 1/9/02
57
CAUTION
When adjusting the brake pedal, make sure
that clearance (a) between the lower end of
the pushrod (1) and the brake pedal (2) is
within specification.
When raising the brake pedal, do not allow the
lower end of the pushrod thread to enter into
the brake pedal joint.
S E RV IC E :
B rake, rear, m aster cylinder
pushrod, clearance
0.04 in (1m m )
FRONT BRAKE LEVER LUBRICATION
1.
Place the vehicle on a stand.
2.
Remove the rubber cover from the brake lever.
3.
Remove the nut (1), pivot bolt (2), and brake
lever (3).
4.
Spray all the parts with a water-displacement
chemical, wipe them off, and dry them
thoroughly.
5.
Install the brake lever and apply a light coat of
high quality waterproof grease onto the pivot
bolt.
NOTE :
Only apply a light coat of grease so it does not
attract a lot of dirt and debris.
6.
Install the pivot bolt and tighten the nut
securely.
7.
Install the rubber boot over the brake lever.
1. Pushrod
2. Brake pedal
a. Clearance
(1)
(a)
(2)
1. Nut
2. Pivot bolt
3. Brake lever
1
2
3
