08 GB
4. MAINTENANCE AND CLEANING
Before cleaning the hob, ensure the appliance has cooled down. Remove
the plug from the socket or (if connected directly) switch off the electricity
supply.
Cleaning and user maintenance shall not be made by children without
supervision.
Never use abrasives, corrosive detergents, bleaching agents or acids.
Avoid any acid or alkaline substances (lemon, juice, vinegar etc.) on the
enamelled, varnished or stainless steel sections.
"WARNING” - Do not use a steam cleaner to clean the hob.
When cleaning the enamelled, varnished or chrome sections, use warm
soapy water or a non caustic detergent. For stainless steel use an
appropriate cleaning solution.
The burners can be cleaned with soapy water. To restore their original
shine, use a household stainless steel cleaner. After cleaning, dry the
burners and replace.
It is important the Burners are replaced correctly.
GLASS HOB
• Avoid spillages, as anything which falls on to the hob surface will quickly
burn and will make cleaning more difficult.
• It is advisable to keep away from the hob all substances which are liable
to melt, such as plastic items, sugar, or sugar-based products.
MAINTENANCE:
- Place a few drops of the specialized cleaning product on the hob surface.
- Rub any stubborn stains with a soft cloth or with slightly damp kitchen
paper.
- Wipe with a soft cloth or dry kitchen paper until the surface is clean.
If there are still some stubborn stains:
- Place a few more drops of specialized cleaning fluid on the surface.
- Scrape with a scraper, holding it at an angle of 30° to the hob, until the
stains disappear.
- Wipe with a soft cloth or dry kitchen paper until the surface is clean.
- Repeat the operation if necessary.
A scraper with a razor blade will not damage the surface, as long as it is
kept at an angle of 30°.
Never leave a scraper with a razor blade within the reach of children.
A FEW HINTS:
Frequent cleaning leaves a protective layer which is essential to prevent
scratches and wear. Make sure that the surface is clean before using the
hob again. To remove marks left by water, use a few drops of white vinegar
or lemon juice. Then wipe with absorbent paper and a few drops of
specialized cleaning fluid. The glass ceramic surface will withstand
scraping from flat bottomed cooking vessels, however, it is always better to
lift them when moving them from one zone to another.
5. AFTERCARE
Before calling out a Service Engineer please check the following:
• that the plug is correctly inserted and fused;
• that the gas supply is not faulty.
If the fault cannot be detected:
Switch off the appliance and call the After Service Centre.
DO NOT TAMPER WITH THE APPLIANCE.
This appliance is marked according to the European
directive 2002/96/EC on Waste Electrical and
Electronic Equipment (WEEE).
By ensuring this product is disposed of correctly, you
will help prevent potential negative consequences for
the environment and human health, which could
otherwise be caused by inappropriate waste handling
of this product.
The symbol on the product indicates that this product may not be
treated as household waste. Instead it shall be handed over to the
applicable collection point for the recycling of electrical and electronic
equipment.
Disposal must be carried out in accordance with local environmental
regulations for waste disposal.
For more detailed information about treatment, recovery and recycling
of this product, please contact your local city office, your household
waste disposal service or the shop where you purchased the product.
6. PROTECTION OF THE ENVIRONMENT
Declaration of compliance:
This equipment, in the parts intended to
come into contact with food, complies with the regulations laid down in
EEC directives 89/109.
Appliance complies with European Directives 2006/95/EC,
2004/108/EC and 2009/142/EC and subsequent
amendments.
This appliance has been designed for non-professional, i.e. domestic, use.
Table 1
İ ŘŐ
Ñ C
Ī
Ñ
Ņ
Ñ
Ǿ
Ñ
ŌŃ
Ñ
Burners arrangement
4Gas
3Gas+1E
5Gas
5Gas
Ė
Þ
Ŕ
ÒÕÒM
ǾŘ
Ę
Þ
ǾŌ
Ñ
Ǿ
(AUX)
-
-
-
-
Semirapid Burner
(SR)
2
2
2
2
Rapid Burner
(R)
2
1
2
2
Ultrarapid Burner
(UR)
-
-
1
-
Quadruple Crown Burner
(QC)
-
-
-
1
Electric Plate
-
1
-
-
Flame failure device
Ignition
Installation Class
3
3
3
3
Product dimension (mmxmm)
Gas Power (kW)
8.5
6.0
12.0
12.0
G20 20 mbar (N.G.) (l /h)
810
572
1143
1143
Gas Power (kW)
8.5
6.0
12.0
12.0
G30/G31 28-30/37 mbar (LPG) (g/h)
618
436
873
873
Voltage (V) /Frequency (Hz)
Electrical Power (W)
1
1500
1
1
595 x 510
Rated power input
745 x 510
YES
220-240 V / 50-60 Hz
Alternative injector kit for LPG gas available in the packaging
Installed Gas type / power
PLV6S
PLV7S
YES