EN-19
Cautions
1. The
ceramic
hob
is supplied
with 16A plug. If instead the un
it is to
be hardwired
it must
be installed by qualified personnel or technicians. We have
p
rofessionals
at your service.
Please never conduct the operation by yourself.
2. The ceramic cooker hob shall
not be mounted to cooling equipment,
dishwashers and rotary dryers.
3. The ceramic cooker hob shall be installed such that better heat radiation can be
ensured to enhance
its reliability.
4. The wall and induced heating zone above the work surface shall withstand heat.
5. To avoid any damage, the sandwich layer and adhesive must be resistant to
heat.
6. A steam cleaner is not to be used.
7. This ceramic can be connected only to a supply with system impedance no more
than 0.427 ohm. In case necessary, please consult your supply authority for
system impedance information.
Connecting the hob to the mains power supply
The power supply should be connected in compliance with the relevant standard,
or a single
-
pole circuit
breaker.
T
he method of connection is shown below.
1. If the cable is damaged or needs replacing, this should be done by an
after-sales t
echnician using the
proper tools, so as to avoid any accidents.
2. If the appliance is being connected directly to the mains supply, an omnipolar
circuit breaker must be
installed with a minimum gap of 3mm between the
contacts.
3. The installer must ensure
that the correct electrical connection has been made
and that it complies
with safety regulations.
4. The cable must not be bent or compressed.
5. The
cable must be checked regularly and only replaced by a properly qualified
person.
