BUILT-IN GAS HOB
INSTALLATION AND USER INSTRUCTIONS
Note: Do not use the hob until you have read the instruction manual
1.INTRODUCTION
Thank you for purchasing a new Gas Hob.
4.SAFETY INSTRUCTIONS
5. INSTALLA TION INSTRUCTIONS
TECHNICAL INFORMATION
The Installation, the adjustments, conversions and maintenance listed in this part must only be
The safety and automatic adjustment devices of the appliance may only be modified by an authorised
The Installation of this gas hob must comply with the standards in force.
This appliance is not connected to a flue for discharge of the combustion products; therefore, it
WARNING!
the relevant instructions regarding ventilation.
The appliance must not be connected to a combustion products evacuation device. It shall be installed
and connected in accordance with current installation regulations. Particular attention shall be given to
must be paid to the instructions given below for ventilation and aeration.
LOCATION
The cooker may be located in a kitchen, kitchen/diner or a bed-sitting room, but not in a room containing
LPG models shall not be installed in a room or internal space below ground level, e.g. in a basement.
carried out by qualified persons.
service agent.
must be connected in compliance with the above mentioned installation rules. Particular attention
The room must have an opening window or equivalent; some rooms may also require a permanent
PROVISION FOR VENTILATIO
The room containing the cooker should have an air supply in accordance with BS 5440: Part 2.
a bath or shower. The hob must not be installed in a bed-sitting room of less than 20m .
3
vent. If the room has a volume between 5 and 10 m , it will require an air vent of 50cm2 effective
3
area unless it has a door which opens directly to
If the room has a volume of less than 5 m ,
3
it will require an air vent of 100 cm effective area (fig.1). If there are
other fuel burning appliances in
2
the same room, BS 5440: Part 2 should be consulted to determine air yent requirements.
open or install a mechanical ventilation device (fig 2).
In particular, when using the grill or more than one hotplate burner, open a window if a mechanical
ventilation device is not operating (fig. 3).
(*)Air inlet minimum section:100c
㎡
Fig 1 Fig 2 Fig 3
UNPACKING THE APPLIANCE
Remove all packaging before use and check to make sure that the appliance is In perfect condition.
If you have any doubts do not use the appliance and call your supplier.
Some parts on the appliance are protected by a plastic film. This protective film must be removed
before the appliance is used. We recommend carefully slitting the plastic film along the edges with
The packaging materials should carefully discarded and not left within easy reach of children as
they are a potential safety hazard.
INSTALLING AND FIXING THE HOB
Your hob can be fitted to any worktop with a thickness of 40 to 50 mm,
accordance with No overhanging surface or cooker hood should be closer to the hotplate than 750 mm.
Fix in position in fig, 4. If fitting a 600 mm bridging unit above the 700 mm hob unit, the sides of
adjacent cabinets may be lower than 760 mm down to 334 mm provided they are resistant to heat and steam.
The hob has a speciaf seal which prevents liquid from entering the cabinet Follow these instructions
seal:
in order to correctly apply this
a sharp knife or pin.
NOTE
: The use of a gas cooking appliance results in the production of heat and moisture in the room
in which it is installed. Always ensure that the kitchen is well ventilated; keep natural ventilation holes
1
2
3
2. YOUR HOB
3.CLEANING
Applicable For gas
477x 557
477x 557
Rapid
gas burner
Semirapid
gas burner
burner
Auxiliary
gas
Material
Flame
failure
device
Power
Supply
Size
(mm)
Built-in
(mm)
Type
580x90
500x
580x90
500x
220-240V
~50Hz
220-240V
~50Hz
Glass
/
/
13.7 MJ/H
13.7 MJ/H
Stainless steel
Yes
Yes
Cod:
3.6 MJ/H
3.6 MJ/H
3.6 MJ/H
3.6 MJ/H
6.3 MJ/H
6.3 MJ/H
6.3 MJ/H
6.3 MJ/H
6.3 MJ/H
6.3 MJ/H
Triple flame
gas burner
13.7 MJ/H
Triple flame
gas burner
Semirapid
gas burner
Triple flame
gas burner
13.7 MJ/H
Semirapid
gas burner
Semirapid
Auxiliary
gas burner
gas burner
Semirapid
Auxiliary
gas burner
gas burner
Even if you have used a gas hob before, it is important that you read these instructions thoroughly
before starting to cook, paying particular attention to the installation and safety instructions. If you
have any problems with installing, operating, or cooking with your hob, please check through these
instructions thoroughly to make sure that you have not missed anything.
WARNING!
For your own safety, make sure that these instructions on Installation, use and
maintenance are followed. We advise you to keep these instructions in a safe place for future
reference. If you sell or transfer ownership of this product, please pass on these instructions to the
new owner.
VITREOUS ENAMEL
Hotplate, burner caps, pan supports.
Cloth wrung out in hot soapy water. Stubborn stains.can be removed with a cream paste.
approved by the Vitreous Enamel Development Council, liquid cleaner or by rubbing with fine steel
wool soap pads.
ALUMINIUM
Hotplate burner bodies.
Similar to paint cleaning above. Use a nylon brush to remove any cleaning materials, water or dirt from
the hotplate burner bodies. After cleaning, wipe dry and refit to the hob ensuring they are correctly
seated.
Check parts are reassembled correctly by lighting the burners and allowing to dry out.
PLASTIC
Control knobs.
Wipe with a cloth wrung out in hot soapy water.
STAINLESS STEEL
Cloth wrung out in hot soapy water.
Ensure that these notes and that the whole of this instruction book are thoroughly read and understood before
installation or operation of the hob.
The instructions are provided in the interest of your safety.
GAS SAFETY (INSTALLATION & USE) REGULATIONS
1.It is the law that all gas appliances are installed by competent persons in accordance with current edition
of the above regulations. It is In your interest and that of safety to ensure compliance with the law.
2.Repairs or servicing of this product must only be carried out by an authorised agent service agent
service agent using only approved parts.
3.No attempt must be made to modify this appliance.
4.Cooking appliances become very hot in use, therefore ensure children and pets are kept away. The use
of oven gloves is recommended when during use.
5.Do not allow children to operate or play with any part of the appliance.
6.Do not use unstable pans and position handle away from the edge of the hob.The use of a suitable hob.
7.In the interests of safety and hygiene, ensure the hob is kept clean as a build up of grease could cause.
8.This appliance is designed for domestic cooking only, commercial catering may invalidate the warranty.
9.Do not cover the hob or place combustible materials on or near the surface even when the hob is not in use.
10.Do not fill deep fat frying pans more than one third full of oil. Do not leave unattended.
11.Before cleaning the hob, switch off at the mains.
12.When finished cooking, switch all controls off and allow to cool.
13.If you sell or transfer ownership of this product, please pass on these instructions to the new owner.
14.This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
15.Children should be supervised to ensure that they do not play with the appliance.
16.If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a
similarly qualified person in order to avoid a hazard.
17.Do not immerse appliance or power cord into water or any other liquids.
18.Please pull the pin out when you do cleaning and maintenance. When the appliance is installed, you
can pull out the pin.
HCG604WFCX2
HCG604WFCX2
HCG604WFCG1
HCG604WFCX2
HCG604WFCG1
HCG604WFCG1
