Modular floating systems
www.candock.com
9441, Bourque Blvd.
Sherbrooke (Qc) J1N 0G2
OFFICE
|
BUR.
T.FREE
|
S. FRAIS
FAX
|
TÉLÉC.
819 847-2599
1 888 547-2599
819 847-3250
P.
8
G2 JETSLIDE ( SEQUENCE )
WARNINGS & SPECIAL INSTRUCTIONS
8-Please note that some boats have cooling intakes for the engine which are located directly on the boats hull .These intakes need to be
under the water line mark when the engine is running.
CANDOCK INC. WILL NOT TAKE ANY RESPONSABILITY FOR ANY TYPE OF
DAMAGE TO A BOAT RESULTING FROM THIS. IT IS THE RESPONSABILITY OF THE DISTRIBUTOR TO MAKE SURE THAT THIS IS
VERIFIED BEFORE SELLING THE INSTALLATION TO THE CLIENT
. We recommend that you inform your clients of that even if you are
sure that the intake will be in the water.
9-The fact of removing cubes at the back of the system to lower the back of the system closer to the water could exert excessive
pressure on the back tabs of the Jetslide and may cause damage which will not be covered by the warranty.
10-All distributors are held responsible for giving training to the customers on the complete use of the system, theoretical and practical
with the watercraft of the customer. Candock Inc. will not be held responsible for any damages resulting from the fact that the operator
did not receive the adequate training.
11-The boats and personnal water crafts must be completely mounted on the Jetslide at all time. A craft left on the Jetslide in a position
where the major part of the weight is left on the back, could exert excessive pressure on the back tabs of the Jetslide and may cause
damage which will not be covered by the warranty.
12-The installation of multiple BOAT Jetslides side to side is possible, but no rows of cubes should be removed with the aim of saving
space. Moreover the totality of the back Jetslide must be left free to be able to go up and down. Therefore, it must not be connected to
the adjacent systems.
13-It is normal that a certain wear of the JetSlide appears at the points of contact where the boat exerts more pressure.
14-All Jetslides produced after the November 1st, 2009 are now filled with foam making them unsinkable.
15-We make a point of specifying that any damages caused by the keel of motors or the propellers will not be covered by our warranty.
16-All systems destined for boats of more than 3000lbs/1360kgs ( propeller or turbine powered) require the air assisted system
NOTE: In certain cases, a winch can be necessary to push the boat back in the water. This may void the neccessity of the air
assisted system. Any damage resulting from non-utilization of this winch will not be covered by the warranty.
(
see specific instructions
)
17-Stiffening beams may be required for your configuration, any damages resulting from non-utilization will not be covered by the
warranty. (
see specific instructions
)*Only the bams provided by Candock inc. are approved.
18-With the numerous varieties of boats on the market, it is possible that certain types will not be compatible with our system. Candock
Inc. cannot be held responsible for this fact. It is impossible for us to be able to test all the existing types of boats in the world.
