Modular floating systems
www.candock.com
9441, Bourque Blvd.
Sherbrooke (Qc) J1N 0G2
OFFICE
|
BUR.
T.FREE
|
S. FRAIS
FAX
|
TÉLÉC.
819 847-2599
1 888 547-2599
819 847-3250
OVERVIEWS
ASSEMBLY PROCEDURE
P.
16
PWC WINCH
Material/Composition :
Zinc plated steel
Aluminum
Needed tools :
9/16” key wrench
Key for nut
or
Ratchet key for nut + ratchet tool
Accesories included with the winch
1 CANDOCK LUG CONNECTOR
1 CANDOCK NUT
1 Aluminum mounting bracket
1 Pulling winch ( 400 lbs capacity )
equipped with a 15 ‘ strap and 1 hook.
Winch to be used mainly with the Jetslide system to help launch your PWC. It can be installed in front to pull it or on the sides for launch
manoeuvres.
1 - Depending on position of the assembly, adjust the angle of the winch on the plate using appropriate holes.
2 – Install
CANDOCK LUG CONNECTOR
/ MOUNTING BRACKET ASSEMBLY where the winch is needed.
3 – Complete by by securely fastening the
CANDOCK NUT
against the
CANDOCK LUG CONNECTOR
as describd in the
BASIC PRODUCTS
OWNER’S MANUAL
*When positionned on the side of the assembly for back-up procedures, position the strap in a straight line with the front of the PWC.
( as pictured on the image )
IF USED TO
PULL-IN
IF USED TO
PULL-OUT
