Modular floating systems
www.candock.com
9441, Bourque Blvd.
Sherbrooke (Qc) J1N 0G2
OFFICE
|
BUR.
T.FREE
|
S. FRAIS
FAX
|
TÉLÉC.
819 847-2599
1 888 547-2599
819 847-3250
P.
10
AIR ASSIST SYSTEM V3 ( RIGID TANK )
3-While the tank is sinking, simply determine the location of the Control Box. Make sure to
place it on the same side as the elbowed fitting you’ve earlier connected to the tank.
*Keep in mind that the overall length of the air hose in 28’ (8.5m).
4-Remove the regular connecting pin that is at the center of the designated location of the
Control Box and replace it with the mounting connecting pin that is found inside the Control
Box.
5-Finalize the positioning of the Control Box by inserting it on through the threaded rod of
the mounting connecting pin. Secure it by screwing the nut and washer kit.
*Make sure that air exhaust of the Control Box are located on the correct side of your system, in accordance with the air hose side and the elbowed fitting that
is connected to the tank.
6- Take the second threaded elbowed hose and connect it to the Control Box, on the highest
exhaust available.
*Mandatory Teflon tape is to be wrapped around the PVC threaded fitting prior screwing it in place.
**Make sure to screw the fitting in a way that will be oriented towards the rear of the system, on the appropriate side of the system, according to the fitting
that is already connected to the tank that is still in the water (left or right).
***Manually tight the fitting until snug, without exaggerating. Make sure that the hose tip will point towards the back of the system and in a 45 degree angles
towards the water.
7-Connect the longest air hose to the Control Box fitting that you’ve just connected to the
Control Box.
*Manually tight the fitting until snug, without exaggerating.
**Ideally, keep the whole hose on the dock while proceeding.
8-While using the rope, or simply by going for a swim, gently slide the tank underneath the
system so that it’s as close as possible to its final position (see picture).
9-Once the tank is in position, use the designated threated steel rods to secure the tank
underneath the system. Remove the loose nut and washer kit from one of the threaded rod
and insert it, from underneath the designated tab of the tank, and pass it through the white
lug connector that is just above the tab of the tank and secure by screwing the nut and
washer assembly back on top Repeat for the remaining rod kits (3). For this step, only tight
the nuts so that you’ll still be able to fine-tune the position of the tank. After the tank has
been perfectly aligned, complete the procedure by firmly screwing the nut and washer
assembly on the threaded rod, without exaggerating.
