A
B
2.4
- COMBINATIONS
INCLUDING UNDER WATER ANCHORING POINTS
IDEAL ASSEMBLY
CONFIGURATIONS AND ANCHORING GUIDELINES FOR “BOAT” JETSLIDE SYSTEMS
Modular floating systems
www.candock.com
9441, Bourque Blvd.
Sherbrooke (Qc) J1N 0G2
OFFICE
|
BUR.
T.FREE
|
S. FRAIS
FAX
|
TÉLÉC.
819 847-2599
1 888 547-2599
819 847-3250
P.
25
RULES:
-Make sure to abide to all pre-mentionned
rules and guidelines.
-If boat is longer than 16.5 ft, a combination
of anchoring products is required.
-If If boat is heavier than 2000 lbs, a
combination of anchoring products is
required.
-The heavier the baot is, the stronger/heavier
the REAR anchor points need to be.
-Anchoring items featured in zone
A
should
always consist of either P
ILINGS, ANCHORING
STRUTS
or
WALL ANCHORAGES
.
-Anchoring items featured in zone
B
should
always consist of either
UNDER WATER
ANCHORING POINTS
or
ROPES AND CLEATS.
-If placed on the side of the system, make sure
the “rear” ropes will allow vertical movement
when BOAT is going up and down the
JETSLIDE
-A Minimum of 4
ANCHOR POINTS
should
be considered at all time.
-Always keep the anchoring symmetrical
left/right
.
-If using
UNDER WATER ANCHOR POINTS
, simply ask your dealer for recommended weight/type of anchors
and special attachments. You will have to use galvanized or stainless steel 5/16”chain or good quality marine rope.
The length will depend on water depth and variations of the water level. When using this type of anchoring, it
is normal that the JetSlide moves slightly forward when entering the unit and backwards when exiting the unit.
This is why you need to check regularly the tightness of the chains to limit this movement.
-
These guidelines are imperative to insure full warranty coverage
-In doubt, please refer to your Candock representative.
